2005 Chevy Uplander Remote Start

I'm in the process of doing a remote starter on a 2005 Chevy Uplander.

1. I'm using a GMBP to bypass the Passkey 3. It says in to hook up the "Blue Fuel Enable Line" but I don't see any blue wire coming out of the PK3 module. I only have:

Pink

The GMBP directions have:

So I'm not sure what to do here.. The directions show 6 wires coming out of the PK3 module while there is acutally 7 and they are all different colors then the directions...

you should be using the instructions for an install 1 on the uplander... not install 3

I thought install 1 was for Passlock 2.. This van has Passkey 3 and I'm using install 2. That's not correct??

I see what I did now.. I didn't see there was an install "2" and I just seen install 3 gm passkey 3 on the bottom but that is just for specific models.

Thanks