05 Colorado & PLXR

Installed Remote Start on 05 Colorado.....with IB-PLXR 3 days ago.Everything went fine...........Now, within 30 seconds of turning Off Ignition Switch, Vehicle will  Remote Start......but if you wait longer, it will NOT Remote Start.  Everything Powers Up, but when it goes to Crank, it just clicks & the engine lite on dash stays on.Tried another PLXR, but same problem..........Any ideas???

make sure you dont have an acc wired as an ign..... it needs to see the acc drop out in order to crank....Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

Thanks for the Reply........Everything is wired correctly......It was working fine for 3 days, now the Remote Start will only work right after you remove the Ignition key........It really has me confused ( again )Changed the Remote Start, the PLXR, & went over wiring & Programming 4 or 5 times.............CRAZY.........Gotta be something simple

Are you positive you are getting constant 12 volts to the plxr???  Also make sure of  a good solid ground..

Yep..........

Have double checked everythingEven changed both units.............Remote Start will start after turning off Ignition switch ( within 1 minute ) after that, Remote Start just goes click when starting to crank & Engine light stays on until i restart with keyDoes anyone have the correct hook-up for PLXR so I can verify wires .??? I cut the White / Blue and hooked in PLXR as I have on other Colorados

THANK YOU....

That is how I have it............1st time I have had a problem like this..........It seems to be a PASS problem, but can'y figure itWill have to wait fot OMEGA tomorrow

what wire did you use for heat a/c and headlightsscooby

WHITE/ Red for AccessoryBROWN / White @ Switch ( - ) Parking Lites

Omega has changed the IB-PLXR, you might ant to use the new versionMO

Don't Learn from Others Mistakes

You Might Be the One That Knows.