290i-c command start

Home / the12volt's Install Bay / General Discussion / 290i-c command start (

Topic Closed)

Welcome Guest :)

Members

< Prev Page Next Page > < Prev Topic Next Topic >

majorj13

Member - Posts: 12

Joined: December 28, 2002

Location: Canada

Posted: December 30, 2002 at 12:39 PM / IP Logged

OK I got the PURPLE / white wire and tapped into it, Now when I start the car with the remote it turnsover starts then shuts off, anymore idas for me thanks again

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: December 30, 2002 at 1:22 PM / IP Logged

The only other one is an injector. Use the uncommon colored one, but then you must program the CD to a 1 cylinder ingine with a medium idle speed.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

majorj13

Member - Posts: 12

Joined: December 28, 2002

Location: Canada

Posted: December 30, 2002 at 1:36 PM / IP Logged

OK, I have programmed it for 1 cyl and tried all three settings for 1a.1b.1c 2cy; & 3 cyl. It seems to start better on 1b this is what happens though, It starts and runs for about 2 seconds and then shuts off. I am baffled what else could it be?

majorj13

Member - Posts: 12

Joined: December 28, 2002

Location: Canada

Posted: December 30, 2002 at 9:45 PM / IP Logged

Whooah, got her working thanks for the help had to use wht wire on coil pack and reset CS and program for 6cyl

Velocity Motors

Moderator - Posts: 12,488

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: December 30, 2002 at 10:43 PM / IP Logged

Awesome !!

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Jet1t

Member - Posts: 8

Joined: January 25, 2003

Location: Canada

Posted: January 26, 2003 at 1:38 PM / IP Logged

It looks like I may have almost the same problem. I bought this 270i without the wiring diagram or book and with the help of this site and its members I have it all hooked up. I'm installing it into an 89 Voyager MiniVan when prssing the trunk button it flashes the lights 10 times. The door lock and un\lock work properly . Pressing the start allows the starter to start the vehicle for approx. 1 second then shuts off. With the tach wire installed to the blk/grey at the coil it does this . If I disconnect the tach wire it starts and stays running for 5 seconds with the starter spinning then shuts off. Is there a reset procedure for command start starters that may help ?

Thanks In Advance

Velocity Motors

Moderator - Posts: 12,488

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: January 26, 2003 at 6:24 PM / IP Logged

You have the wrong tach wire. It should be a gray or gray/black .

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Jet1t

Member - Posts: 8

Joined: January 25, 2003

Location: Canada

Posted: January 26, 2003 at 7:52 PM / IP Logged

Yes sorry my typo error it is connected to the grey coil wire.

Jet

Velocity Motors

Moderator - Posts: 12,488

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: January 27, 2003 at 8:05 AM / IP Logged

Is this a 6 cylinder or a 4 cylinder engine ?

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Jet1t

Member - Posts: 8

Joined: January 25, 2003

Location: Canada

Posted: January 27, 2003 at 10:12 AM / IP Logged

Its a 3.0 V6 .

Jet

< Prev Page Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.