2003 Sunfire alarm wiring

12 VOLT CONSTANT   RED (+)    IGNITON SWITCH HARNESS    = (pin 1) on 6 pin starter harness

STARTER  YELLOW (+)   IGNITION SWITCH HARNESS     = (pin 2) on 6 pin starter harness

STARTER 2  N/A     

 IGNITION 1  PINK (+)  IGNITION SWITCH HARNESS   = (pin 3) on 6 pin starter harness green

IGNITION 2  N/A      

 IGNITION 3  N/A         ACCESSORY /HEATER BLOWER 1  ORANGE (+)   IGNITION SWITCH HARNESS = (pin 4) on 6 pin starter harness blue     ACCESSORY /HEATER BLOWER 2  N/A         KEYSENSE  N/A         PARKING LIGHTS ( - )  N/A         PARKING LIGHTS ( + )  BROWN (+)   IN DRIVERS KICK PANEL  =    POWER LOCK  LIGHT BLUE (TYPE C) See NOTE *1   IN EITHER KICK PANEL      POWER UNLOCK  WHITE (TYPE C) See NOTE *1   IN EITHER KICK PANEL      LOCK MOTOR WIRE  GRAY (+)   IN DRIVERS DOOR HARNESS    

DOOR TRIGGER  See NOTE *2   IN DRIVERS KICK PANEL and PASSENGER KICK PANEL   14301_SUNFIRE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf

  DOMELIGHT SUPERVISION  GREEN/ BLACK (-)   IN DRIVERS KICK PANEL = (pin 7)on 14 pin main harness grey wire      TRUNK RELEASE  BLACK/ WHITE (+)   @ BCM, See NOTE *3      SLIDING POWER DOOR  N/A       

HORN  BLACK (-)   @ STEERING COLUMN HARNESS    

 TACH  PURPLE / WHITE   IN MAIN ENGINE HARNESS      WAIT TO START LIGHT  N/A         BRAKE  WHITE (+)   @ SWITCH ABOVE BRAKE PEDAL = (pin 8)on 14 pin main harness red & white wire    FACTORY ALARM DISARM   N/A         ANTI-THEFT  YELLOW (+) and BLACK (-) and WHITE (Not Used)   GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug  thats what i got so far

newbie99 wrote: the link i posted is my alarm almost the same as the 6000 yes now for the wiring pin 5 orange armed output connects where and pin 12 yellow generator + input conects where pin 11 purple bypass output connects to the passlock pin 13 blue is the trunk - input

Orange = armed output, sounds like a negative trigger to activate a starter kill relay Yellow 'Generator + input', sounds like it needs to be hooked to an ignition wire (Ignition 1 pink) Purple bypass output = use this to activate your passlock bypass module. It will be the module's - input. Blue Trunk input - = to black in trunk at light Please seperate your questions into sentences, or seperate statements. Running the question together like that throws it off and confuses things. Good Luck Keep us posted