need 98 corvette alarm diagram

Home / the12volt's Install Bay / Car Security and Convenience / need 98 corvette alarm diagram (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mainlyrich

Member - Posts: 2

Joined: April 07, 2006

Location: United States

Posted: April 08, 2006 at 2:00 AM / IP Logged

I need 98 corvette alarm diagram and bcm pinouts

88vette

Member - Posts: 38

Joined: February 14, 2006

Location: United States

Posted: April 08, 2006 at 10:48 AM / IP Logged

Go to www.bulldogsecurity.com and look under wiring diagrams.

Here is what it says:

CORVETTE

1997 -2001


		GM's VATS ANTI-THEFT System, Requires 791 Bypass Module

PART	COLOR	LOCATION	DIAGRAM
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY /HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH
POWER LOCK	RED / BLACK (TYPE B)	IN EITHER DOOR HARNESS
POWER UNLOCK	ORANGE / BLACK (TYPE B)	IN EITHER DOOR HARNESS
LOCK MOTOR WIRE	GRAY (+)	IN DRIVERS DOOR HARNESS
DOOR TRIGGER	GRAY/BLACK(-) and BLACK/ WHITE(-) Use both, See NOTE *2	@ BCM, See NOTE *4	10585_CORVETTE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ BCM, See NOTE *4
TRUNK RELEASE	LIGHT BLUE (-)	@ BCM, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ BCM, See NOTE *4
TACH	WHITE	@ PCM, See NOTE *3
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN (-)	INSIDE DRIVERS DOOR
ANTI-THEFT	See NOTE *1	GM's VATS System @ Ignition Switch

NOTES

NOTE *1 The VATS (Vehicle Anti Theft System) wire may be (2) thin YELLOW wires, (2)thin TAN wires or (2) thin WHITE wires, these wires are usually in a ORANGE or BLACK HEAT SHRINK TUBE, but at times are left out of the tube and ran by themselves up under the dash to the security module.

NOTE *2 The GRAY/BLACK (-) is for the DRIVERS DOOR and the BLACK/ WHITE (-) is for the PASSENGER DOOR, when connecting to an ALARM SYSTEM, us both wires and DIODE ISOLATE See DIAGRAM

NOTE *3 The PCM (Power Control Module) is located on the PASSENGER SIDE OF THE ENGINE COMPARTMENT. You will need to remove the right front tire and remove access panel in the Inner fender to get to the PCM. The TACH WIRE is located in the BLUE connector Pin 35.

NOTE *4 The BCM (Body Control Module) is located in the PASSENGER FOOTWELL under the CARPET

NowYaKnow

Gold - Posts: 1,217

Joined: December 18, 2002

Posted: April 08, 2006 at 2:06 PM / IP Logged

Here's the pinouts for the 3 connectors at the BCM. I formatted the first one, then got lazy on the other two..

BCM Connector 1: 24 Pin

A1 - Not Used

A2 - Not Used

A3 WHT/BLK - Ignition Key Resistor Feed

A4 ORN - Fuse Output - Type III Fuse

A5 Not Used

A6 Not Used

A7 Not Used

A8 Not Used

A9 BLK/WHT Ground - Clean

A10 Not Used

A11 Not Used

A12 BLU DK - Interior Lamp Relay Output - Coil

B1 Not Used

B2 PPL/WHT Ignition Key Resistor Return

B3 GRY Rear Fog Lamp Relay Control (Export)

B4 DK GRN/WHT Fog Lamp Relay Output - Coil

B5 Not Used

B6 LT GRN Serial Data Signal - Class B - 10400 BAUD - Diagnostic To Body Module

B7 GRY ABSTRNS Relay Control

B8 Not Used

B9 LT BLU Trunk Release Relay Output - Coil

B10 BLK Horn Relay Output - Coil

B11 BRN Fuse Output - Ignition 3 - Type III Fuse

B12 Not Used

BCM Connector 2: 32 Pin

DK BLU

Back Up Lamp Relay Feed - Coil

GRY/BLK

745

Door Ajar Switch Signal - LT FRT

WHT

193

RR Defogger Relay Output - Coil

ORN

640

Fuse Output - BATT - Type III Fuse

Not Used

TAN

159

Key Reminder Switch Output

Not Used

PNK/BLK

109

Hood Ajar Switch Signal

C10

PPL

681

Rear Defogger Switch Signal - Secondary

C11

Not Used

C12

RED / BLK

744

Trunk Ajar Switch Signal

C13

Not Used

C14

LT GRN

Key Reminder Switch Signal

C15

LT GRN

1601

Steering Column Lock Signal

C16

Not Used

BLK/WHT

746

Door Ajar Switch Signal - Right FRT

Not Used

ORN

192

Fog Lamp Switch Output - FRT

LT BLU

187

Fog Lamp Switch Output - RR

Not Used

DK BLU

Turn Signal Lamp Feed - RT FRT

LT BLU

Turn Signal Lamp Feed - LT FRT

BLK

1576

Trunk Release Switch Output

D10

Not Used

D11

Not Used

D12

YEL

243

Fuse Output - Accessory - Type III Fuse

D13

PNK

1039

Fuse Output - Ignition 1 - Type III Fuse

D14

Not Used

D15

BRN/WHT

1571

Traction Control System Switch Signal

D16

ORN

1915

AAS Modulator Feed - LT RR

BCM Connector 3: 16 Pin

Not Used

BLK

150

Ground

GRY/BLK

690

Courtesy Lamp Relay Output - Coil

ORN

2540

Not Used

PPL

1604

Steering Column Unlock Feed

LT BLU/BLK

1914

AAS Modulator Output - Hold - LT RR

ORN

1603

Steering Column Lock Feed

BRN

1244

I/P Lamp Feed #2

YEL

390

I/P Panel Lamp Feed - Tertiary

Not Used

YEL

183

Fog Lamp Indicator - FRT

Not Used

GRY

Instrument Panel Lamp Feed

YEL/BLK

625

Vehicle Anti - Theft System Starter Enable Relay Output Coil

TAN

159

Key Reminder Switch Output

mainlyrich

Member - Posts: 2

Joined: April 07, 2006

Location: United States

Posted: April 08, 2006 at 5:24 PM / IP Logged

Thats guys this is exactly what I needed.

88vette

Member - Posts: 38

Joined: February 14, 2006

Location: United States

Posted: April 08, 2006 at 9:45 PM / IP Logged

Glad to be of help!

need 98 corvette alarm diagram - Last Post -- posted image.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

need 98 corvette alarm diagram

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.