how to set up subs with amp

hi to all i am after some information about how to connect my subs to my amp..i have a infinity d-class mono sub amp and 2 12 inch alpine type s subs.. does anbody no wat the wire configeration is for connecting them?? What is the best ohm to set it at and how is this acheived?? thanks any help appreciatedcrzyvs

Look at the specs of your subs;  at the actual voice coil configuration.  These would probably be one of three different configurations:  Single voice coil (SVC) 4 ohm, dual voice coil (DVC) 4 ohm, or DVC 2 ohm.  When you have found what these are, look at the woofer wiring wizard in the left column help section under Car Audio.  Generally, if it is possible, a final 2 ohm load is chosen for use with a sub mono amp.  Do not use a 1 ohm load, but you can use a 4 ohm load.Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.

it it pos from amp to pos on sub and neg from amp to neg from sub the on sub pos to negcrzyvs

Sounds like you have the ohm load too low. Post the specs of the subs and amp.'85 Toy