alpine 8040 led not working

Home / the12volt's Install Bay / Car Security and Convenience / alpine 8040 led not working (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

mg8t7gn

Member - Posts: 1

Joined: September 02, 2006

Posted: September 02, 2006 at 1:21 PM / IP Logged

Newbie here. I took notice today that the led for my Alpine 8040 doesn't blink. The alarm system itself works. I can arm/disarm it and the siren goes off when I open the door. The last door closed- 10 seconds until it self arms works. I tried another led and it, too, doesn't work. The grounds for both the led and disarm/valet switch appear to be ok. Where would I start to look? Thanks.

Mark

Back to Top

soundzplusinc

Member - Posts: 22

Joined: May 02, 2006

Posted: September 02, 2006 at 5:23 PM / IP Logged

welll---

The Old Alpine LED's are 2v - soo use a Meter .. ck it ..

if it has 2v - then the LED is bad ...

Try that

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

alpine 8040 led not working

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.