95 GMC Vandura 2500 OEM removal

Home / the12volt's Install Bay / Car Audio / 95 GMC Vandura 2500 OEM removal (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Benji999

Copper - Posts: 81

Joined: January 14, 2005

Location: United States

Posted: October 27, 2006 at 10:33 AM / IP Logged

What's up everybody?? I am replacing the factory hu in a 95 gmc vandura 2500 work van. I hit a snag though, after pulling the trim panel off of the OEM radio, and extracting the screws holding the radio in, it is hung on the right (passengers) side and will not budge, the left (drivers) side slides perfectly fine. Any ideas as to what this could be? There is plenty of clearance to pull the radio.

Back to Top

doibuy

Copper - Posts: 177

Joined: March 15, 2006

Posted: October 27, 2006 at 11:36 AM / IP Logged

There should be a bracket on the passenger side of the radio that is bolted to the center hump of the van. you have to take off the lower sections to access the 10mm bolt.

Back to Top

Benji999

Copper - Posts: 81

Joined: January 14, 2005

Location: United States

Posted: October 27, 2006 at 12:26 PM / IP Logged

So just pull the section out below the trim piece and search for a 10 mm bolt??

Back to Top

sparkie

Platinum - Posts: 2,061

Joined: November 06, 2003

Location: Canada

Posted: October 27, 2006 at 2:22 PM / IP Logged

Take the cover off over top of the engine cover. It is held in by 4 Phillips screws. Two behind the asstray cover and two at the bottom near the floor. There is a 10 mm bolt that screws into a bracket attached to the dash in front of the engine cover near the firewall. This holds the radio in and braces the back of it.

sparky

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

95 GMC Vandura 2500 OEM removal

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.