Sharp corners for glassing?

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / Sharp corners for glassing? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

dkeshish

Copper - Posts: 92

Joined: December 01, 2005

Location: United States

Posted: November 07, 2006 at 11:59 PM / IP Logged

Hi guys I am in the process of making a cover for where my amps are out of fiberglass, the hole for viewing the amps are in question here, when fiberglassing do I try to get the corners as sharp as possible? how would i do this? should i just get it down and then fix the edges of the square hole (for the amp to show) with bondo? thanks all

Back to Top

maglin

Copper - Posts: 206

Joined: June 30, 2004

Location: United States

Posted: November 08, 2006 at 12:05 AM / IP Logged

what angle?

i'm under the impression here that you use MDF to create corners and edges, rabit the MDF a bit to give the glass a pocket to sit in and bondo right over it.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Sharp corners for glassing?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.