Clifford RSX3.5 Alarm

the attenna is plugged in. will try reprogamm, but sure I have attempted - open door turn key to on press and release program switch number of times required for channel then press and hold - i choose once so as to auto learn LED flash, horn honk - NONE all connected but not working. LED does work when I perform shutdown diagnostics Maybe it's th doors - I will check this again also Any more helpo greatly appreciated. to go or not to lar

thanks - will have to get it working first in order to decide if I need it any louderCheersto go or not to lar

Have power. Have control. Alarm will arm and disarm via remote. all doors activate alarm. Sensor sensing and activates alarm. hood pin activates alarm. however, - when arming or disarming the siren doesn't chirp... - the doors don't lock... - the remote start doesn't work... Not doing badly - now 5 days with no diagrams and no previous experience - I do have you though, that helps!to go or not to lar

Okay whislt you were all snoozing I have been fiddling... now down to two problemos: Lcoks and remote start. Locks: - green wire connected to unlock car wire - shows 12v on neg. tester wire and flicks to 0v when unlocked returns to! 12v - blue wire connected to lock car wire - as above but only when locked... when I set alarm the doors do not lock??? How do you get the doors to lock when alarm is set? ---------------------------------------- Remote Start Controller initiates remote start, but engine does not start. manual says that purple wire ((+) STARTER OUTP! UT TO STARTER (STARTER SIDE) should have 12v running through it a few seconds after initiation, but does not it rests at 0v When I start the car normally the wire does have 12V running through it. I have checked power connections and fuses and they are fine. There is lots of clicking but no start. Help! By the way the siren is chirping happily now that it is grounded correctly.to go or not to lar

Help please... Locks: I have blown 3 fuses attempting to use relays to get my doors to lock on alarm set. I definitly got the relays to click, but the doors had no effect upon them. In the harness there are several wires, 12v, ground, and two wires which are read through the neg wire as 12v dropping one dropping on lock and the other on unlock. I have used relays which switch from neg. to 12v and ther other way around and nothing. Do you think I have the wrong wires???? Please give me a way forward.to go or not to lar