I don't know if you need audio, security, remote start or nav so I will send all I have....
12volts red & RED / white + ignition harness
Starter yellow + ignition harness
Second Starter
Ignition pink + ignition harness
Second Ignition white + ignition harness
Accessory orange + ignition harness
Keysense lt. green - ignition harness
Power Lock RED / black - BCM, to right of glove box
Power Unlock ORANGE / black - BCM, to right of glove box
Notes: The door lock wires will only meter when turning the key in either door key cylinder.
Also have to program the door lock pulse duration for 3.5 seconds to unlock the doors.
On vehicles without the factory alarm, use lt. blue for lock and white for unlock. Find the wires in either kick panel.
Lock Motor gray BCM, to right of glove box
Unlock Motor tan BCM, to right of glove box
Parking Lights+ brown drivers kick or light switch
Parking Lights- BROWN / white BCM, to right of glove box
Door Trigger gray/black - BCM, to right of glove box
Notes: To avoid the domelight delay use tan for the drivers door, blue for the passenger door and the liftgate,
and orange for the sliding doors. All wires are negative trigger, located at the BCM and all need to be diode isolated
from each other.
Dome Supervision use door trigger
Trunk/Hatch Pin tied in with doors
Power Sliding Door lt blu/blk (L), lt blue (R) - each kick, harness to rear
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock
Notes: To disarm the factory alarm without unlocking the doors, use a 0.8 second pulse on the unlock wire.
Tachometer PURPLE / white ign coils or PCM
Notes: The ignition coil pack is on the top of the engine on the passenger side.
The PCM is in the air cleaner assembly on the front of the engine compartment on the driver side,
the wire is in the blue plug in pin 8.
Brake Wire white + brake switch
Horn Trigger black - BCM, to right of glove box
Immobilizer Bypass Required:
PASS-Key III
Part #: 555GW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes:
Interface Module: Category:
Combo Interface Required:
Yes Type:
Data Bus
Part #: 1700G
Alternate Part1 #: 457GW
Notes: Can use the 1700G or 457GW to bypass the PASS-Key III, but it will not control the door locks on this model year.
Radio 12v orange
Radio Ground BLACK/ white
Radio Ignition yellow
Radio Illumination gray/black
LF Speaker +/- tan - gray
RF Speaker +/- lt. grn - green
LR Speaker +/- brown - yellow
RR Speaker +/- blue - lt. blu
Speed Sense green BCM, to right of glove box
Wipers purple + wiper motor
Notes: This wire is only activated when the wipers are in the high/fast position. There is not a wire for the low setting.
LF Window up/dn blue - brown A drivers window switch
RF Window up/dn lt. blu - tan A drivers door harness
LR Window up/dn not recommended
RR Window up/dn not recommended
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty.
It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.