Looking for 2001 Chev Venture Diagram

Looking for 2001 Chev Venture Diagram. I seen a 2002 one in here but not sure if they would be the same?

I don't know if you need audio, security, remote start or nav so I will send all I have....

12volts  red & RED / white   +   ignition harness 

Starter  yellow   +   ignition harness  Second Starter          Ignition  pink   +   ignition harness  Second Ignition  white   +   ignition harness           Accessory  orange   +   ignition harness          Keysense  lt. green   -   ignition harness  Power Lock  RED / black   -   BCM, to right of glove box   Power Unlock  ORANGE / black   -   BCM, to right of glove box  Notes: The door lock wires will only meter when turning the key in either door key cylinder. Also have to program the door lock pulse duration for 3.5 seconds to unlock the doors. On vehicles without the factory alarm, use lt. blue for lock and white for unlock. Find the wires in either kick panel. Lock Motor  gray      BCM, to right of glove box  Unlock Motor  tan      BCM, to right of glove box  Parking Lights+  brown      drivers kick or light switch  Parking Lights-  BROWN / white      BCM, to right of glove box           Door Trigger  gray/black   -   BCM, to right of glove box  Notes: To avoid the domelight delay use tan for the drivers door, blue for the passenger door and the liftgate, and orange for the sliding doors. All wires are negative trigger, located at the BCM and all need to be diode isolated from each other. Dome Supervision  use door trigger        Trunk/Hatch Pin  tied in with doors                         Power Sliding Door  lt blu/blk (L), lt blue (R)   -   each kick, harness to rear  Factory Alarm Arm  arms with lock        Factory Alarm Disarm  disarms with unlock        Disarm No Unlock          Notes: To disarm the factory alarm without unlocking the doors, use a 0.8 second pulse on the unlock wire. Tachometer  PURPLE / white      ign coils or PCM  Notes: The ignition coil pack is on the top of the engine on the passenger side. The PCM is in the air cleaner assembly on the front of the engine compartment on the driver side, the wire is in the blue plug in pin 8.          Brake Wire  white   +   brake switch           Horn Trigger  black   -   BCM, to right of glove box  Immobilizer Bypass  Required:PASS-Key III Part #: 555GW Alternate Part1 #: 556UW Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes:  Interface Module: Category:Combo Interface  Required:Yes Type:Data Bus Part #: 1700G Alternate Part1 #: 457GW Notes: Can use the 1700G or 457GW to bypass the PASS-Key III, but it will not control the door locks on this model year.

Radio 12v  orange      

Radio Ground  BLACK/ white        Radio Ignition  yellow     Radio Illumination  gray/black              LF Speaker +/-  tan - gray        RF Speaker +/-  lt. grn - green    LR Speaker +/-  brown - yellow      RR Speaker +/-  blue - lt. blu     

Speed Sense  green      BCM, to right of glove box 

Wipers  purple   +   wiper motor  Notes: This wire is only activated when the wipers are in the high/fast position. There is not a wire for the low setting. LF Window up/dn  blue - brown   A   drivers window switch  RF Window up/dn  lt. blu - tan   A   drivers door harness  LR Window up/dn  not recommended        RR Window up/dn  not recommended 

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty.

It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

Thank you very much sir! That was more than enough!