Adding clean sweep to ’06 Avalanche nav

Home / the12volt's Install Bay / Car Audio / Adding clean sweep to ’06 Avalanche nav (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Ren92

Copper - Posts: 56

Joined: September 26, 2004

Location: United States

Posted: November 28, 2006 at 8:40 PM / IP Logged

I have a 06 Avalanche with the fact Nav and Bose combo. I the Clean sweep and the CL-SSI and went to the spkr output at the doors but I am not getting a clean signal at all. Anyone done this truck with a clean sweep and have good luck and if so where did you pick up signal for the units?

Back to Top

2old4gamez

Member - Posts: 5

Joined: February 08, 2004

Location: United States

Posted: December 13, 2006 at 3:43 PM / IP Logged

if your truck has a factory amp, then u need to hook the cleansweep up to the speaker inputs at the factory amp.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Adding clean sweep to ’06 Avalanche nav

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.