alarm/remote start, 99 chrysler lhs

I have a ungo/clarion alarm and remote start and i wanted to know how exactly i set up or wire a xk03 with a 99 chrysler lhs transponder along with the alarm and lock/unlock part as well.

Super easy, but the XK03 wont do the transponder, it;ll arm/disarm/locks/trunk.. ya ned a pkuch to do the transponder. just hook the outputs from the alarm to the wires on the xk03 and a ground when running/12v/gnd and run the data wire... ithink the firmwarev is chdl2 for the xk03 also..Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

i have a ungo sr6000 and a 99 chrysler lhs and im using a xk03 w/ chdl2. It will lock but not unlock or the other way around will unlock but not lock its one or the other. Any ideas?

I have  a ungo rs6000 and a 99 chrysler lhs and im using a xk03 for my locks and everything and i having problems getting them to lock and unlock.... well they will do one but not the other like lock but not unlock or unlock and not lock....?!?!?!

My car says it needs 620ohm, 900ohm, 1.6kohm, and 2.7kohm. I have only been able to find a 2.7kohm what can i do or where can i buy some?

Radio Shack will have what you need. You may have to use more than one resistor to achieve the values you require. Check this page on how series and parallel circuits affect resistor values.

Parts express is a good source for electronic components. Some of their resistors can get a bit pricey, so it depends on what you're doing with them if you need to get the better quality ones. Parts express resistorsAlso, to match those resistor values without getting a resistor that matches the value exactly, you can combine them. In series, you can just add the values of resistors to get the total, for parallel, use this calculator.

How do i configure a relay for my trunk release. 99 chrysler lhs