2003 Pontiac Bonneville Alarm/RS Wiring
Welcome Guest :)
jamez99
Member -
Posts: 1
Joined: December 20, 2006
Location: United States
Posted: January 13, 2007 at 6:30 PM / IP Logged
I would like a wiring diagram for my 2003 Pontiac Bonneville to install a remote starter with immobiliaer/bypass. thanks.
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: January 14, 2007 at 12:55 PM / IP Logged
| Wire/Function | Colour | Location/Description | Polarity |
| PASSIVE ANTI-THEFT | YES | TRANSPONDER | SEE NOTES |
| 12 VOLTS | Red | at battery or behind fusepanel | + |
| | | It is recommended that you find an alternate power source than the one from the ignition switch since this wire is a very small gauge. |
|
| IGNITION | Pink | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| IGNITION 2 | White | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| ACCESSORY | Orange | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| STARTER | Yellow | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| KEY SENSE | Lt.green | Ignition switch | - |
| TACH SIGNAL | White | At coil pack on right side of engine | AC |
| LOCK | RED / black | At switch in driver's door | - |
| | | This is a multiplex doorlock system. You must run wires into the driver's door to interface the doorlocks. |
|
| UNLOCK | ORANGE / black | At switch in driver's door | - |
| | | This is a multiplex doorlock system. You must run wires into the driver's door to interface the doorlocks. |
|
| DRIVER LOCK MOTOR | Gray | In driver's door at switch | + |
| DRIVER UNLOCK MOTOR | Tan | In driver's door at switch | + |
| PASSENGER UNLOCK MOTOR | Tan | In passenger door at switch | + |
| DOORPIN | BLACK/ white | In each individual door | - |
| DRIVER DOOR LATCH | Tan | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
| FACTORY ARM | Tan | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
| FACTORY DISARM | Lt.green | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: January 14, 2007 at 12:56 PM / IP Logged
| BRAKESWITCH | White | At switch above brake pedal | + |
| PARKLIGHTS | BROWN / white | At light switch harness | - |
| HORN | Black | At steering column | - |
| DRIVER WINDOW UP | Dk.blue | At switch in driver's door | REV POL |
| DRIVER WINDOW DOWN | Brown | At switch in driver's door | REV POL |
| PASSENGER WINDOW UP | Dk.blue | At switch in passenger door | REV POL |
| PASSENGER WINDOW DOWN | Brown | At switch in passenger door | REV POL |
| LEFT REAR WINDOW UP | Dk.blue | At switch in left rear door | REV POL |
| LEFT REAR WINDOW DOWN | Brown | At switch in left rear door | REV POL |
| RIGHT REAR WINDOW UP | Dk.blue | At switch in right rear door | REV POL |
| RIGHT REAR WINDOW DOWN | Brown | At switch in right rear door | REV POL |
| HEADLIGHTS | White | At steering column | - |
| VSS WIRE | Dk.GREEN / WHITE | Cruise control module | AC |
| DATABUS INTERFACE | Pin-2(top row from left) | Diagnostic plug below dash | DATA |
Follow the12volt.com
Tuesday, November 25, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
