is this setup a match?

Home / the12volt's Install Bay / Car Audio / is this setup a match? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

onsatmex5

Copper - Posts: 52

Joined: June 06, 2004

Location: United States

Posted: August 08, 2007 at 8:32 PM / IP Logged

Will this be enough power to properly run this setup?

KICKER ZX1000.1 1000 W. MONO AMP, Pushing 2 kicker 10 inch L7's in a vented enclosure?

Back to Top

jeffchilcott

Platinum - Posts: 2,483

Joined: April 11, 2002

Location: United States

Posted: August 08, 2007 at 9:12 PM / IP Logged

RMS power of the L7 10's are 750 each, the ZX1500.1 would be a better match, but the ZX1000 will work just fine. Make sure you buy the correct impedance woofers to match the 2ohm minimum load the ZX amps like.

2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR

2007 USACI World Champion

2007 World Record

2006 USACI Finals 2nd Place

Back to Top

onsatmex5

Copper - Posts: 52

Joined: June 06, 2004

Location: United States

Posted: August 09, 2007 at 4:09 PM / IP Logged

I have 2 of these subs in a vented enclosure,

http://caraudiosecurity.com/shop/product/products_id/2562.html

RMS Power Range (Watts) 75-600 , The ones I have are the older ones, Can I run them @ 2ohm's using the KICKER ZX1000.1 , I am a little confused!

It says, In addition, each coil may be connected to a different amplifier channel and each channel will see a 2 ohm load.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

is this setup a match?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.