07 charger trunk release

I installed a aftermarket amp to the factory deck in a 2007 dodge charger and after I was done the truck release didn't work anymore any suggestions??

The obvious things would be making sure you didn't pinch a wire, short anything out, unplug anything and forget to plug it back in. I have first hand experience with an 06 Charger that the passenger rear window would not roll down in anymore shortly after I installed a remote start (lock/lock no less). It had nothing to do with the remote start but the dealer insisted it did. I removed the system completely then they took the car back to the dealer, the dealer replaced the control module (not sure which) under warranty and I re-installed the starter with no further problems. It is possible it is just bad timing/luck.Installer, IT support, and FFL. I need less hobbies.

Well Im thinking its a fuse but when i look in the book there is no fuse marked for the trunk release do you happen to know which one it could be?

What makes you think it would be a fuse? Did something short? Test all of the fuses it only takes a couple of seconds to test them. Hook your DMM black lead to ground, and probe each end of the fuse. If you get a fuse that has +12V on one side and nothing/ground on the other side the fuse is blown.Installer, IT support, and FFL. I need less hobbies.