Autotek 400.4 Amp in fault

Home / the12volt's Install Bay / Car Audio / Autotek 400.4 Amp in fault (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

jcdinglaz

Member - Posts: 1

Joined: October 14, 2003

Location: United States

Posted: December 19, 2003 at 8:24 PM / IP Logged

I have an Autotek 400 watt 4ch Super Sport series amp. The amp powers up fine, but when I plug in an RCA to any of the 6 on the amp, the red light comes on. I have found that When the outer conductor from the RCA I am plugging in contacts the amp, the fault indicator comes on. I understand this is a ground issue, any other issues I over looked, or Ideas on correcting this. If any Ideas to this problem could you PLEASE email me at jcdinglaz@yahoo.com

Thank you

Jason

jay

forbidden

Platinum - Posts: 5,353

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

Joined: November 01, 2003

Location: Alberta, Canada

Posted: December 20, 2003 at 5:57 PM / IP Logged

Disconnect all of the speaker leads, then start hooking the rca's up one at a time, if the amp goes into protection with only the rca's hooked up (no speaker leads) then you have a fault with the amp. If the amp is not in protection, start hooking the speakers up one wire at a time, if the amp goes into protection, check for a speaker wire or speaker going to ground.

Top Secret, I can tell you but then my wife will kill me.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Autotek 400.4 Amp in fault

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.