the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

alarm, odom light not working


Post ReplyPost New Topic
< Prev Topic Next Topic >
abcgt 
Member - Posts: 13
Member spacespace
Joined: April 18, 2009
Location: California, United States
Posted: May 16, 2009 at 11:36 AM / IP Logged  

I have a Ultrastart 2280 alram/remote start. I had the alarm side working. Never got to the remote side of it. But the alarm was working. Then all of a sudden the alarm stopped working. and I noticed that the odom. light was dim.  Checked wire connection and could not find anything wrong.  A few days latter the odom. light started working but the alarm still does not. The alarm will not churp ( no power coming out of alarm module) and if any sensors are trigured will not go off. Can not reset alarm. It will lock and unlock doors as if the alarm is set.  Also, no power to the lights. When it is set the lights flash once along with horn.

2000 Chevy Impala LS

Thanks For your Help

howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: May 16, 2009 at 12:35 PM / IP Logged  
See if the alarm is in valet mode, also odometer light unlikely to be a related problem, depending on where your light output was taken to, or a wiring error
abcgt 
Member - Posts: 13
Member spacespace
Joined: April 18, 2009
Location: California, United States
Posted: May 16, 2009 at 12:53 PM / IP Logged  

I thought that but I can not get the alarm to reset. The horn will not sound and the lights will not blink as they should. I do not have power coming out of the horn wire from the alarm to horn when trying to arm, but the doors lock and the indicator light turns on.

The lights are wired to the brow/white wire behind the dimmer switch.  All other lights on the dash work as tehy should.  Just can not figure out if they are tired in together or two different problems. The two problems happened at the same time..

i am an idiot 
Platinum - Posts: 13,716
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: May 16, 2009 at 3:24 PM / IP Logged  
Does the odometer and the gear indicator also out?   Is it a green or blue fluorescent type display?
abcgt 
Member - Posts: 13
Member spacespace
Joined: April 18, 2009
Location: California, United States
Posted: May 16, 2009 at 3:40 PM / IP Logged  

Yes the Odometer and the gear indicator is out. It is a green fluoresent display. Those two items are the only two that are affected but must be on the same circuit. Was thinking of taking that whole asm out and checking the bulb but do not know if that is a good idea. What you think?

i am an idiot 
Platinum - Posts: 13,716
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: May 17, 2009 at 8:00 AM / IP Logged  
I have never repaired one out of an Impala, I have repaired several Buicks.  On the Buicks there are 4 resistors that heat up and lose contact with the circuit board.  They are not located anywhere near the indicator.  They are located on the far right of the cluster.  No idea where they are going to be in your vehicle.  If you take the cluster apart and can not find them, take a few pictures and post them here.  They are not through hole resistors, they are round surface mount devices.  Round resistors soldered to a flat circuit board, I have no idea why they get bad connections.  After I resolder them, I use a dab of silicone on each, that way if it does reheat, the silicone will hold it in place.  One of the ones I repaired was missing one of the resistors.  It works fine with just 3. It was my wifes car.  If there was a problem with the missing resistor, she would have pointed it out by now.
abcgt 
Member - Posts: 13
Member spacespace
Joined: April 18, 2009
Location: California, United States
Posted: May 17, 2009 at 8:45 PM / IP Logged  
Thanks for the info. hopefully I can take a look at it during the week and if needed I'll pose the pics.
THanks again.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, July 13, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer