2006 kia sedona, bulldog deluxe 500

i have a bulldog deluxe 500 im going to install in my wife's KIA sedona ex. i also have an xpress xk01 with the kiadl 4.0 firmware on it. i think i have all understood except one thing. It say the courtesy light circuit will require a rely if it draws over 250ma, this sounds quit low to me but i would love to have this option working. should i wire in a relay or will it be fine the way it is? don't forget its a mini van and has a lot of courtesy lights.. thanks in advance

2006 KIA Sedona

Use a relay.Let's Go Brandon Brown. Congratulations on your first Xfinity Series Win. LGBFJB

thank you

the unit has a built in relay for the parking light rated at 10 amps. that one should be fine right?

Both audiovox and wiremagic are showing the parklights as a NEG. wire. Read the manual to see if you can change the parklight wire of the bulldog to a NEG. output.

there is no way of removing the cross member under the crash pad except for cutting the dash on the right hand side? i guess i need to remove this to gain access to the wiring?

there is 2 10mm bolts that hold that bracket in place. They suck to get out but it can be done. I usually take the phillips head screw out of the bottom and pry the panel foward a little then use my 10mm swivel socket to get in there. There even harder to get back in Good luckIf i Can't Install it    I Don't need it   Joe

i got another question. with the xk01 firmware kiadl it said to grab the "data wire - brown wire of twisted pair in drivers door harness." kiadl2 says to grab data wire at "bcm, blue wire twisted with red, over blue ringer. i guess i have to grab this one for the power sliders to work? if so does any one know of a hole a can find in the firewall to gain access? also there are two plugs on the side of the bcm which one has the pair im looking for?

joe363 wrote: i got another question. with the xk01 firmware kiadl it said to grab the "data wire - brown wire of twisted pair in drivers door harness." kiadl2 says to grab data wire at "bcm, blue wire twisted with red, over blue ringer. i guess i have to grab this one for the power sliders to work? if so does any one know of a hole a can find in the firewall to gain access? also there are two plugs on the side of the bcm which one has the pair im looking for?

Connect to Blue wire (twisted pair with Red wire) Harness located over a blue ringer and plugged on left side of BCM<---where do i find this wire???