keyless entry, 2008 pontiac g6

Purchased keyless entry to Pontiac g6 2008 w/o keyless entry with power door switch.

After review installation manual. Not sure if I can do it.

Open the fuse box in driver’s side compartment, the wire is in a block with fuse on one side and wires in hole of block.

Anybody have an easy approach how to id wires.

Thank You   

	Power Unlock		WHITE		(-)		AT BCM MODULE BEHIND TRIM AT FRONT OF CENTER CONSOLE ON PASSENGER SIDE	...	*
	PowerLock		WHITE		(-)		AT BCM MODULE BEHIND TRIM AT FRONT OF CENTER CONSOLE ON PASSENGER SIDE		...**

Here's a schematic for the locks...Relays may not be needed depending on UNIT>>>? http://documents.audiovox.com/700649.pdf

*..........PIN #66 - TAN PLUG, USES 1.5K RESISTOR TO GROUND TO TRIGGER UNLOCK

**.........PIN #66 - TAN PLUG - USES STRAIGHT GROUND TO TRIGGER LOCK

And a Meter...! What keyless entry unit did you buy(make and model #)...Here's the power connections too...

Battery		RED / WHITE		(+)		IGNITION SWITCH HARNESS
	Ignition 1		PINK		(+)		IGNITION SWITCH HARNESS

Bulldog ke1702

Thanks

Follow the KE1702 instructions for a Type B (-) door lock system.  Go to Radio Shack and buy a 1500 ohm resister and use the Bulldog instructions for you cars door locks :  http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp   at the bottom of the page.  The White wire in your car is found with the above listed info from Tommy.

Good luck.

If you have a Factory alarm on the car you might have to hook up the FASD wire.

Additionally you can hook up the Parking Light (-) output to the car to flash the lights on lock & unlock.

And if you have an electric trunk pop switch in the car you can attach that wire also to allow remote control of the trunk release. 

You will need a Digital Multi- Meter to help you safely locate the correct wires.

Bulldog Security web site has the cars wiring and their Tech Support is pretty good ( expect to be on hold for a while ).

http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp