dei 529t

just wanted to say hi and thanks for any help in advance! i got a 02 nissan sentra spec v. im trying to install the 529t to operate my sunroof. only issue im having is that it just pulse little by little when i try to activate it with the remote to open with my 3303 remote. also when i arm the system it also pulse to close..ive been trying to figureout how to get a full negative signal instead of small pulse but i dont know how, been going at this for a few days now....hopefully i can solve this issue. also .ive done the 530 to both my front window....and i know that the 530 have adjustable resistance.....but the 529 dont......im completely lostSpecvay

To close are you using the same output (GWA) you used with the 530t but diode separated? To open it will only move for as long as you hold the button and then it will take 1.5 seconds before responding.

yes im using the same ground to arm as i did with my 530t....all i did was spice it in with my orange 530t wire harness... i did hold the aux button, all i get is a pulse and a crack of the sunroof...... i still have the gray and gray/black wire i didnt use....im so lostSpecvay

Look in the instruction manual, the section that says combine both modes, it might be your answer.

i will look for it in the 529 instruction manual, i dont recall seeing anything like that but i will look at it again tomorrow.... this is definity making me so mad....Specvay

Seen my signature line, the part where it says read the manual?

ive read the instruction completely i have it setup correctly....i thinking i need the pulse generator by dei....anyone else got input or ideas? please help thanks!Specvay

Have you gone to the motor wires?

i can only go to the motor becuz the sunroof switch only work with ignition on..... im assuming i need the dei 528t pulse generator...... or mayb buy another 530t instead of using the 529t. im completely lostSpecvay

The switch isn't relevant, you're getting power through the 529t red wire. This is similar:- B3E_honda_roof_ii.bmp