the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

C3-RS730 LCD wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
mcculleb 
Member - Posts: 6
Member spacespace
Joined: December 11, 2015
Location: Pennsylvania, United States
Posted: December 11, 2015 at 6:14 AM / IP Logged Link to Post Post Reply Quote mcculleb
Hello
Purchase the C3-RS730 LCD and Idatalink asd-acla module. After reading all instructions, I have one question.
Do I need to run the wires to the ignition and start wires directly from the remote start, the vehicle, and to the data link module or is it only required to run the ignition and start wire from the remote start to the data link?
Thank you.
Brian McCullen
mcculleb 
Member - Posts: 6
Member spacespace
Joined: December 11, 2015
Location: Pennsylvania, United States
Posted: December 11, 2015 at 6:15 AM / IP Logged Link to Post Post Reply Quote mcculleb
Sorry, 2011 Honda CRV
Brian McCullen
beegbie 
Copper - Posts: 341
Copper spacespace
Joined: August 17, 2002
Location: United States
Posted: December 14, 2015 at 7:29 PM / IP Logged Link to Post Post Reply Quote beegbie
Hey Brian, you need to hook up the wires from the remote start to the car. Follow the guide for the ignition connection form the alca to the immobilizer plug and you will only need to wire the starter input from the remote start to the alca if your not in dbi mode.
The guys over at ads do not give you the remote start to car connections in this guide.
mcculleb 
Member - Posts: 6
Member spacespace
Joined: December 11, 2015
Location: Pennsylvania, United States
Posted: December 14, 2015 at 8:23 PM / IP Logged Link to Post Post Reply Quote mcculleb
Thanks for the response. I understand about going from the rs to the module on the start circuit and the musical starring the vehicle via can bus. What I didn't understand was the wiring for the ignition wire. It shows on the musical that it is an input going to ignition. I'm guessing I will also have to hook up the ignition wire from the rs and the input wire on the module to the vehicle ignition wire.
Brian McCullen
mcculleb 
Member - Posts: 6
Member spacespace
Joined: December 11, 2015
Location: Pennsylvania, United States
Posted: December 14, 2015 at 8:24 PM / IP Logged Link to Post Post Reply Quote mcculleb
Module, not musical. Lol... Stupid auto correct.
Brian McCullen

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer