Noob alarm, ungp s100

Home / the12volt's Install Bay / Car Security and Convenience / Noob alarm, ungp s100

Welcome Guest :)

Members

< Prev Topic Next Topic >

dparrtech

Member - Posts: 1

Joined: January 14, 2016

Location: Nevada, United States

Posted: January 14, 2016 at 12:35 AM / IP Logged

Hey everybody, I have a quick question. I'm running an (ancient) ungo prosecurity s100 on my rock crawler. Everything was working fine, until, like an idiot, I bumped my antenna (was laying under the dash pad) and the wires knocked out of their plastic connector to the antenna. The wire appears to be a 4 pin connector at the brain, and a 4 pin connector at the antenna, with three wires. Is this a generic cable? I see a 4 pin/ 3 wire at

http://www.drdetailshop.com/543B.htm

Does this seem like a viable solution? Everything works fine and Id rather not replace the whole alarm and keyless entry (not factory power locks in my 83) if I can help it. Or am I pretty much SOL and need to pony up for a whole new system. If I do, any rough ideas on what that might set me back?

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.