2007 yukon with DB3 having issues with RXT

Home / the12volt's Install Bay / Car Security and Convenience / 2007 yukon with DB3 having issues with RXT

Welcome Guest :)

Members

< Prev Topic Next Topic >

cokelly

Member - Posts: 2

Joined: January 12, 2017

Location: Alberta, Canada

Posted: October 23, 2017 at 4:06 PM / IP Logged

Hello

I installed a DB3 with an XL202, 7765V remote and 6816T antenna. I have wired it just like the install guide says but after sitting for a few hours the viper remote won't work. The factory remotes work fine. I believe the vehicle is going into sleep mode. If I run the +12volt direct to another source will that solve my problem? Currently, all the wires go the OBd2 connector.

Thanks

cokelly

Member - Posts: 2

Joined: January 12, 2017

Location: Alberta, Canada

Posted: October 23, 2017 at 9:10 PM / IP Logged

One other solution I read was to run a negative output to the (-) door trigger. Would that mean to run the (-) RAP off out put to the (-) door trigger.

Can someone confirm this?

xxrzdxx

Member - Posts: 17

Joined: March 15, 2008

Posted: December 26, 2017 at 7:46 PM / IP Logged

Did you ever find a solution to your problem, I'm afraid I'm having the same problem.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.