Remote Start Installation, 2012 Chevrolet Express, Viper 5305v & DB3

Home / the12volt's Install Bay / Car Security and Convenience / Remote Start Installation, 2012 Chevrolet Express, Viper 5305v & DB3

Welcome Guest :)

Members

< Prev Topic Next Topic >

sapiophile

Member - Posts: 1

Joined: August 20, 2019

Location: Ohio, United States

Posted: August 20, 2019 at 11:38 AM / IP Logged

2012 Chevrolet Express van w/factory keyless entry

I am installing a Viper 5305v and a Directed DB3

The DB3 is being installed using the original wiring instructions, NOT THE RSR or RXT instructions.

I'M NOT USING THE W2W wiring, but rather the DATA wiring.

I am using the D2D cable with red end between the 5305v and DB3.

I have found which wires to hook up on the DB3, but I do not know which wires I am supposed to hook up between the Viper 5305v and the vehicle.

The DB3 interfaces with the CAN bus on the vehicle, so which wires on the remote starter (5305v) are actually supposed to be hooked up.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.