2006 Chevrolet Silverado, Viper 5706V

Home / the12volt's Install Bay / Car Security and Convenience / 2006 Chevrolet Silverado, Viper 5706V

Welcome Guest :)

Members

< Prev Topic Next Topic >

calvinjk

Member - Posts: 1

Joined: July 01, 2019

Location: Colorado, United States

Posted: September 02, 2019 at 9:41 AM / IP Logged

Hello kreg357,

I've been reading your posts on installation of the Viper 5706V and the use of a bypass module. I have a 2006 Silverado work truck, automatic trans and power door locks but does not have an immobilizer system on it so I'm attempting to install the 5706V without a bypass module. Can this be done without a bypass module? If so, my questions are; where do I get the door input signal? The door switch is at 12v when the door is closed and drops to 0v when the door is opened. Can this input be used on either green or violet wire on the 24 pin connector? Next, lock and unlock output. Can these be connected directly to the BCM somehow? If so, might you know which wires to connect to? If not, how would you suggest tying into the door lock?

Thanks, calvinjk

Calvin K

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.