the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

95 dodge stealth, rs problem


Post ReplyPost New Topic
< Prev Topic Next Topic >
profuse007 
Gold - Posts: 2,015
Gold spacespace
Joined: October 20, 2002
Location: Texas, United States
Posted: December 26, 2003 at 9:55 PM / IP Logged  
95 dodge stealth
viper 791xv
when i rs, it start but then shut down right away, however it retry for second time, it start up perfect....other than that, everything else works out great.
what could be the problem?
black-12volt constant
blue-acc
BLACK/ white-ign
blue/orange-2nd ign
the 3 diagrams i have is a bit diff w/ ign wires.
anyone....plz
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
ck auto 
Copper - Posts: 257
Copper spacespace
Joined: September 20, 2003
Location: Canada
Posted: December 26, 2003 at 10:15 PM / IP Logged  

hi the info i have is 12v white

starter is black\yellow

ign is black\white

ign2 is blue black

acc is blue\white

sounds like ing wires wrong check these wires out hope it helps also how did your tach signal learn did you have any problems with it try setting for low tach threshold on rs

good luck
kirk
profuse007 
Gold - Posts: 2,015
Gold spacespace
Joined: October 20, 2002
Location: Texas, United States
Posted: December 26, 2003 at 10:26 PM / IP Logged  
i had three diff diagram with what you had up there, but i self test some of the wires since it doesnt match.
tach learned sucessfully. i dont think its the tach cause it start for like 1 second and cuts off(like in the middle of cranking). but the thingy is that, it starts up perfectly the second time.
unlike when you have no tach or wrong tach, the starter will crank for about 2 sec or more.
imma try to test those ignition(s)/acc again and repost the result, cause the diagram i got from here, techsoft, and bulldoggsecurity are the same but diff from the car, at certain wires.
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
ck auto 
Copper - Posts: 257
Copper spacespace
Joined: September 20, 2003
Location: Canada
Posted: December 26, 2003 at 10:34 PM / IP Logged  

hi try relearning the tach with the brakes on and car in gear this creates a stronger tach signal if that doesn't work relearn tach with car revved up a little bit some people say this doesn't work but it's worked for me before with viper products

good luck
kirk

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, July 24, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer