99 taurus + commando ke-30 keyless entry

hey,

im about to install the commando ke-30 keyless entry on my 1999 taurus se. can anyone give me a link or send me a diagram to wire the whole thing? and what type of power locks does the taurus have? postive? negative?

thx all

--pete

also, what is the best thing to use to splice the wires?

thx again

--pete

what i usually do when splicing into wires is i use my automatic wire strippers to strip the outer sheet away from the wire but not to break the wire in half. Then i use a pick to push through the middle of the exposed wire making a hole, then i feed the alarm wire though the hole like if you were threading a needle, then wrap the alarm wire around the car wire, solder it, then tape it. Makes for a solid connection. As for the wiring diagram here ya go.

thx for all that info. also, do you have a diagram in graphical form? and do you solder in the car? i cant take these wires out ya know ;) heh. do you recommend using the clips to slice the wire (ill try to find out what they are called exactly)? thx for all the info.

thx

--pete 

all the wiring diagrams ive ever seen dont show you exactly were the wires are just the general area, pretty much power is usually in a bundle of wires right under the dash below the steering column, door triggers and power lock/unlock sometimes is just behind the drivers side kick panel, you just have to unwrap the wires if they are taped or in wire loom and test the wire that the diagram shows is supposed to be the wire just to verify that its correct. And for solder yes I do it in the car, i usually stick a mat on the floor board so if solder drips it wont burn the carpet. I dont like T-taps just cause i dont wanna take a chance of it working loose, some people say if you do it right its just as good as solder but i like to solder.

thx 4 all the info again. btw, do you know if the taurus locks are positive of negative?

thx man

--pete

lol, sorry. thx again all

--pete

they are negative, if you look in the diagram i posted the column next to the wire color says either + or -