dodge ram 1500 quad 2002 power locks issu

hello,

i have installed a new alarm (clifford rs 2.5) with door unlock/lock and also disarm factory alarm.i used the corect resistors stated on this site and now when the truck and alarm is off the door lock button only locks the doorsit does not unlock them. the alarm works fine. maybee i screwed something up

any suggestions?????????

lvt

lowvoltagetech.com

it sounds like you dont have the right resistors in place.....i just helped someone with the same problem on a stratus....the info was wrong and he had to use a meter to measure the door lock wire to get the correct value...see if the following info helps... Power Lock WHITE/ DARK GREEN 14 PIN CONNECTOR IN DRIVER #217 Power Unlock SINGLE WIRE SYSTEM KICK PANEL *** *** WHITE/ DARK GRN Wire Must See Ground Through 820 Ohm Resistor For Lock And Ground Through 330 Ohm Resistor For Unlock.Alt: 220 Ohms. Confermed By More Than One Source The 220 Ohm Worked On Unlock. #217 See Single Wire Resistor Door Lock Circuit Diagram OEM Alarm Arm LT GRN/ORANGE DRIVER KICK PANEL * OEM Alarm Disarm SINGLE WIRE SYSTEM *LT GRN/ORANGE-Arm/Disarm Must See A Ground Pulse thru a 1.5K Ohm Resistor To Arm/Lock and a Ground Thru A 550 Ohm Resistor To Disarm/Unlock Use Double Pulse Unlock.Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt