Velocity or anyone pls. help!!

2001 ford f 150 light duty one of my programs say that the gem shuts down after the doors have been locked a certain amount of times and that it has to be woken up. will thiss effect anything if its not hooked up in a vehicle without factory keyless. this is the car in my previous post about the 5 wire door locks. if i dont wake up the gem, will the doors not unlock after a certain amout of time?

what will happen if the gem is not connected to the unlock part of the door locks???? i finished the locks on the ford with some good new s and bad news. The good news is they work with the remote,the bad news is i think i fried the master switch in the car well at least the remotes work with the locks.hey velocity the pink/green wire in the passenger door is not the correct wire and will fry  the switch if connected as a switch wire in an alternating setup.it shows ground all the time and does not change the wire that does work is the pink/black and pink / YELLOW it actually looks like orange not yellow.the pink / YELLOW or orange whatever color it is is the lock wire off the switch on the passenger side if getting in the passenger door.How much will this cost me for a new switch in this car??????im so dumb i know sorry but it wa sa bad day.

velocity can you explain this  lock system to me, how it works, like what makes the master switch a master? i know why the switch burnt because i sent a positive direct to a negative but what was the negative going to was it a motor lead or was it going to the master switch?I understand this a little better but not totally and i need to or this will happen again .i always hated door locks and never got good at them i did most of my studying on other things and i should have studied this more.I am happy because i got the locks working through the remote but i am upset i burnt the switch or switches. Can you help me please?

if i give the BLACK/ white wire power will these locks work again?? The BLACK/ white is the constant to the passenger switch.It lost power after the mistake i made it has no power now.

anyone?????

how do you know you burnt the switch. You may have blown a fuse. Hw do you know if that's the main switch?

i dont but i did burn a fuse and it still dont work after replacing fuse maybe  i need to check again??

yescheck it again, you may have to do some more reconnections