more pats trouble

Home / the12volt's Install Bay / Car Security and Convenience / more pats trouble (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

ucmwp

Member - Posts: 7

Joined: October 11, 2002

Location: United Kingdom

Posted: October 22, 2002 at 9:19 PM / IP Logged

Hi. I have a 1999 mustang saleen and I installed a alarm with remote start. I also got a PKF keyless bypass. I have tried programming this bypass but the theft light continues to blink.....this is how I have been programming.....key one in the ignition on position until theft light goes out, take it out, put key two in the ignition on position, then put it in the off position, then connect the wire that goes to the bypass output on the alarm to ground and turn the key to the on posistion till the light goes out again......This is what it says to do, however when I take it out, a few seconds later the theft light comes back on and starts to blink again.....HELP PLEASE.

ucmwp

Member - Posts: 7

Joined: October 11, 2002

Location: United Kingdom

Posted: October 23, 2002 at 8:49 AM / IP Logged

HELP PLEASE, it started this morning like normal then it just all of a sudden died and the theft light started blinking....I tried to restart it then it was fine and never stalled again....any suggestions on programming this box?

Ohmz

Copper - Posts: 193

Joined: May 09, 2002

Location: United States

Posted: October 23, 2002 at 4:19 PM / IP Logged

whay I remember to program Paths, you need to put key one in to the ignition, turn it to the on position, then take it out and put key 2 in, turn on and then off... take tha key out and remote start the vehicle right away. If your remote start has a bit of a delay and doesn't start right away, use the wire that needs the negative input to make it start right away. This part is very important. The whole process should not take longer than ten seconds.

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: October 25, 2002 at 10:15 AM / IP Logged

You only have 5 seconds maximum between each step. Are you connecting the wires within 5 seconds after the second key is pulled ?

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

more pats trouble

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.