clifford 300, central locking

Home / the12volt's Install Bay / Car Security and Convenience / clifford 300, central locking (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

ace.3

Member - Posts: 8

Joined: April 29, 2005

Location: United Kingdom

Posted: April 29, 2005 at 2:22 PM / IP Logged

hi all hears the problem,i have a clifford 300 and i wish to use it to lock and unlock the doors.

i have tried the relays and even a central interface modual.

basically the clifford lock pulses only 2 volts and the same with the unlock,how can i use the alarm to lock and unlock my car.

also the car is a ford escort s reg which is a 12 volt lock and unlock on it.

i have looked at the diagrams and everything i am at my teather with this.

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: April 29, 2005 at 7:45 PM / IP Logged

If the alarm is only putting out 2V then the alarm is bad. I would triple check that reading though.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

ace.3

Member - Posts: 8

Joined: April 29, 2005

Location: United Kingdom

Posted: April 29, 2005 at 7:54 PM / IP Logged

on the spec it say 150ma max from these wires lock and unlock,i have also put a meter accross it ,i was told that that is enough to go to a relay and switch that so to get a 12v suply to a motor,

auex

Platinum - Posts: 5,041

Joined: December 23, 2002

Location: Arizona, United States

Posted: April 29, 2005 at 9:17 PM / IP Logged

ma has nothing to do with the voltage it puts out. If it isn't sending out 12V then it won't operate a relay or anything else for that matter.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

ace.3

Member - Posts: 8

Joined: April 29, 2005

Location: United Kingdom

Posted: May 05, 2005 at 8:37 AM / IP Logged

took the alarm apart and found that some of the componets were burnt,and ic and a resistor,anyway even used a locking modual and nothing,so i binned it and bought another alarm,toad a 606i and fitted it with no probs all central locking a ok now.thanx for all that helped.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

clifford 300, central locking

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.