wiring diagram for a 1996 dodge ram 3500

Its a diesel.. and I want to hookp up a alarm/remote strater to it.. what avise can i get to hook this up on a 24v system?  And I need the wiring diagram.     Pls Help

Hope the diagram will help you out. Are you sure it's 24V? I've never seen one. DIRECTWIRE™ WIRING INFORMATION - DODGE / RAM PICKUP / 1996 / Remote Start 12volts red or pink/black    +   ignition harness Starter yellow or blu/yel    +   ignition harness Second Starter           Ignition dk. blue    +   ignition harness Second Ignition           Third Ignition           Accessory BLACK/ orange    +   ignition harness Second Accessory           Keysense           Power Lock ORANGE / purple   5wi lt blue plug in driver kick Power Unlock pink/purple   5wi lt blue plug in driver kick Lock Motor           Unlock Motor           Parking Lights+ BLACK / YELLOW      yellow plug in driver kick Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger yellow    -   yellow plug in driver kick Dome Supervision use door trigger        Trunk/Hatch Pin           Hood Pin           Trunk/Hatch Release           Power Sliding Door           Factory Alarm Arm           Factory Alarm Disarm           Disarm No Unlock           Tachometer gry/blk, blk/gry   AC   ignition coil Notes: Also located as gray/blue at large plug through firewall on drivers side at highest point of firewall, also gray/blue at cluster. Wait to start ORANGE / black   -   PCM Notes: The PCM (Powertrain Control Module) is on the passenger side firewall under the hood. Brake Wire WHITE/ brown    +   brake pedal switch Parking Brake           Horn Trigger dk. GREEN/ red    +   relay at fuse box Notes: Also BLACK/ red (-) at column or relay. Memory Seat 1           Memory Seat 2           Memory Seat 3           Interface Module: Category: Immobilizer Bypass Required: No Type: N/A Part #: N/A Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thank you so much... and its a 12v excuse my mistake

You are quite welcome. Be careful whose advice you buy, but be patient with those who supply it.