programming a Code Alarm remote

Home / the12volt's Install Bay / Car Security and Convenience / programming a Code Alarm remote (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

fredzeppelin256

Member - Posts: 1

Joined: August 26, 2005

Location: United States

Posted: August 26, 2005 at 8:21 PM / IP Logged

Hey y'all ! A couple of years ago, my remote for my Code Alarm security system broke, and I just got a used remote from a friend who used to have the same exact system. The problem is, the previous owner had the system installed and I don't have any of the installation manuals. I was told to check out the forums on this site, so I signed up today. Hope somebody can help me!

I know there is a specific sequence you have to flip the valet switch, so my question to you all is.....does anyone know the sequence?

If it helps, the remote's FCC ID is GOH-MX1. Thanks everyone!

Search for other posts by fredzeppelin256

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: August 26, 2005 at 9:56 PM / IP Logged

GOH-MX1........doesn't show up on FCC check.........

Don't Learn from Others Mistakes

You Might Be the One That Knows.

vicko6369

Member - Posts: 1

Joined: August 27, 2005

Location: United States

Posted: August 27, 2005 at 4:46 PM / IP Logged

try this: ignition on, door open (make sure the dome light is on) press an hold the valet switch for about 10 secs, till you hear 3 chirps, then while still holding the valet press the lock button on your remote, that should be it

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

programming a Code Alarm remote

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.