Installing AutoPage 855 in 05 Dodge Ram

I downloaded the wiring diagram for my truck and I have the diagram from my alarm. I have always installed my own alarms but this one is intimidating... I need some help guys... The Direct wiring diagram says to lock I need a 820 ohm negative, and to unlock I need a 330 ohm negative load, How do I do this? It also says I must use relays? The door trigger is done with each door having a individual wire... I followed the 1076 direct diagram it recommends, Where do i get these diodes and where do i put them?? Any other info would help... Thanks!

As far as the diode isolation......all the diode lines (cathode) end, need to face the door FROM the BCM.

Relays as follows youll need 2, one for lock, one for unlock.. Pins 86 get constant fused 12v. pins 85 get triggered from your alarm. pins 87 get grounded.

pins 30 go to the one lock/unlock wire on the truck THRU the resistors. remeber pins 30 will have the resistors in line...then hook them to the purplr/green in the truck.  

Good Luck, let me know if you need any other help!

KarTuneMan 

05 RAM Quad 1500 I got a guide from someone and it says lt. green for Lock motor and tan/lt. green for Unlock motor and should be 5wi connected could you explain 5wi

Thanks in advance

flipper56