Programming remote for avital 2300

http://www.avital.com/guides/igs/avital2300_install.pdf pg 23 Open door Turn ignition on Press the Valet button 8 times. Press it once more, but this time hold it. You should hear 8 chirps. Press any button on the transmitter (press it atleast twice)Note: You Always Dont Get What You Pay For.

I tried pressing the valet button 8 times then on the 9th holding it but it doesn't chirp at all.  Any suggestions?  I unplugged the unit and when i plug it back in it starts chirping and the alarm starts sounding. Then i press the valet switch and it cuts the alarm off.  But still I tried to press it 8 times and on the 9th nothing.

I think you are in valet mode Read the install manual it explains how to turn it off and stuffNote: You Always Dont Get What You Pay For.

Thanks for the help man.  I found out that my pin switch on the driver door was messed up therefore the alarm wasn't reading that the door was opened.  But now that i have fixed that, the transmiter programs to the alarm but in the install manual it says that channel one works the arm/disarm/panic feature.  Well when i program it, the arm button works all 3 options.  You press the arm button once and it arms, press it again and it disarms, hold it in and it goes in panic mode.  What have i done wrong?  Thanks for the help so far.

Ok i'm retarded.  I wasn't paying attention to channels 5,6,and 7.  Thanks for all your help man.  This website is the best.