2004 Ford F450 Diesel

Looking for wiring info for a 2004 Ford F450 Diesel, for remote starter instalation. Thanks

DIRECTWIRE™ WIRING INFORMATION - FORD / F SERIES SUPER DUTY / 2004 / Remote Start [PRINT THIS PAGE] 12volts      yellow & lt. GREEN/ purple       +       ignition harness Starter      green       +       ignition harness Second Starter      N/A             Ignition      RED / lt. green or WHITE/ yellow       +       ignition harness Second Ignition      N/A             Third Ignition      N/A             Accessory      gray / YELLOW & RED / black       +       ignition harness Second Accessory      blue/lt. green       +       ignition harness Keysense                  Power Lock      see notes             Notes: Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. On the vehicles with keyless entry the GEM shuts down after the doors have been locked for a certain time period, to wake up the system refer to DirectFax document 1094. Power Unlock      see power lock notes             Lock Motor      pink/black       5wi      VSM Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. Unlock Motor      RED / orange       5wi      VSM Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. Parking Lights+      brown       +       headlight switch Parking Lights-      N/A             Hazards      same as turn signals             Turn Signal(L)      lt grn/wht (F), lt grn/org (R)      +       steering column Turn Signal(R)      wht/lt blu (F), org/lt blu (R)      +       steering column Reverse Light      BLACK/ pink       +       fuse box Door Trigger      BLACK/ lt. blue       +       passenger kick panel Dome Supervision      use door trigger             Trunk/Hatch Pin      N/A             Hood Pin      N/A             Trunk/Hatch Release      N/A             Power Sliding Door      N/A             Factory Alarm Arm                  Factory Alarm Disarm                  Disarm No Unlock                  Tachometer      NOT RED / lt. green       ac       any ignition coil Notes: On diesel vehicles the tach wire is GREEN / WHITE in a 5 wire harness held up with white tape behind the parking brake release. Wait to start      see DirectFax document 1091             Notes: On the remote start, make sure to program the Accessory State During Wait To Start to ON. Brake Wire      lt. green       +       brake pedal switch Parking Brake      lt. GREEN/ red       -       parking brake switch Horn Trigger      blue       -       steering column or VSM Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. Memory Seat 1      BROWN / lt. green       -       memory mod under dr seat Memory Seat 2      BLACK/ orange       -       memory mod under dr seat Memory Seat 3      N/A       -       Interface Module:      Category: Immobilizer Bypass      Required: No      Type: N/A Part #: N/A Notes: Smart Starter Kill Relays: Not Available warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Thanks, now the wait to start, what wire is that or how do i get DirectFax document 1091?

1091 is a diagram of how to use a 528T, which is just a pulse timer. Just check your installation manual and see if it has a diesel mode, all of the new DEI product (atleast what I have seen) has a menu programmable option to delay the starter for a preset amount of time. What is the make and model of your starter?