1999 Prizm w/Vampire combo Alarm Starter

Hi All -

I successfully installed a Vampire combo alarm/starter in my girlfriend's '99 Chevy Prism.  The only hitch is that I can't get the parking lights to flash during arm/disarm/start.  Using wiring diagrams from this site, I can get either the right or the left, but not both parking lights to flash.  Wiring them in parallel will give me hazard lights everytime the turn signal is used.  I attempted to find the wire for both parking lights at the headlight switch, but can only seem to find the turn signals; I'm basically a backyard installer, so any advice would be greatly appreciated. 

Thanks!

Joe

hi    the pl wires are + green at botom of fuse box and - lt GREEN/ black at steering collumn.  hope this helps

kirk

thanks a million! 

BTW...I just realized that the only door pin that triggers the alarm/disarm is the driver's door pin.  Is there a wire that I can tap that will trigger when any of the four doors is opened/closed?

Cheers -

Joe

hi   

there is 5 RED / white wires at the fuse box the one that goes to the instrament cluster is the one you want you may have to meter them all to find the one that gets all doors.good luck

kirk

Thanks Kirk  -

Are all 5 wires in the same harness?

Joe

hi sorry it took so long to respond computer virus. The wire are all bunched together in the same harnes as far as i know 

thx kirk