2002 bonneville remote start diagram
Welcome Guest :)
eng1
Member -
Posts: 6
Joined: December 20, 2007
Location: Oklahoma, United States
Posted: December 22, 2007 at 7:30 PM / IP Logged
just wondering if a 2002 wiring diagrams for remote start are the same as a 01 bonneville if not could use the 2002 thanks
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: December 23, 2007 at 10:34 PM / IP Logged
| PASSIVE ANTI-THEFT | YES | TRANSPONDER | SEE NOTES |
| 12 VOLTS | Red | at battery or behind fusepanel | + |
| | | It is recommended that you find an alternate power source than the one from the ignition switch since this wire is a very small gauge. |
|
| IGNITION | Pink | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| IGNITION 2 | White | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| ACCESSORY | Orange | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| STARTER | Yellow | Ignition switch | + |
| | | These wires are all small gauge but can be connected normally. |
|
| KEY SENSE | Lt.green | Ignition switch | - |
| TACH SIGNAL | White | At coil pack on right side of engine | AC |
| LOCK | RED / black | At switch in driver's door | - |
| | | This is a multiplex doorlock system. You must run wires into the driver's door to interface the doorlocks. |
|
| UNLOCK | ORANGE / black | At switch in driver's door | - |
| | | This is a multiplex doorlock system. You must run wires into the driver's door to interface the doorlocks. |
|
| DRIVER LOCK MOTOR | Gray | In driver's door at switch | + |
| DRIVER UNLOCK MOTOR | Tan | In driver's door at switch | + |
| PASSENGER UNLOCK MOTOR | Tan | In passenger door at switch | + |
| DOORPIN | BLACK/ white | In each individual door | - |
| DRIVER DOOR LATCH | Tan | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
| FACTORY ARM | Tan | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
| FACTORY DISARM | Lt.green | 8-pin plug on driver's door module | - |
| | | This is a multiplex system. You must go into the driver's door to interface these wires. Pulse a ground (-) to the TAN wire at the same time as lock to arm the factory alarm, diode isolate. |
|
| BRAKESWITCH | White | At switch above brake pedal | + |
| PARKLIGHTS | BROWN / white | At light switch harness | - |
| HORN | Black | At steering column | - |
Follow the12volt.com
Tuesday, October 28, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
