
2002 Ford F-250 Alarm/Remote Start Wiring
Welcome Guest :)
draasch
Gold -
Posts: 2,172
Joined: February 07, 2003
Location: Florida, United States
Posted: May 22, 2004 at 11:18 PM / IP Logged
heys guys,
i am at the station tonight and have an install here for one of the guys atht i work with. i dont have my notes with me for that truck. can someone help me out???
thanks.....
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
raydawg357
Silver -
Posts: 769
Joined: June 17, 2003
Location: United States
Posted: May 24, 2004 at 7:59 AM / IP Logged
DIRECTWIRE™ WIRING INFORMATION - FORD / F SERIES SUPER DUTY / 2002 / Remote Start [PRINT THIS PAGE] 12volts | yellow & lt. grn/pur | + | ignition harness | Starter | green | + | ignition harness | Second Starter | | | | Ignition | RED / lt. green | + | ignition harness | Second Ignition | | | | Third Ignition | | | | Accessory | gry/yel & RED / blk | + | ignition harness | Second Accessory | blue/lt. green | + | ignition harness | Keysense | | | | Power Lock | | | | Notes: Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. On the vehicles with keyless entry the GEM shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1094. | Power Unlock | | | | Notes: Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. On the vehicles with keyless entry the GEM shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1094.Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. On the vehicles with keyless entry the GEM shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1094. | Lock Motor | pink/black | | VSM | Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. | Unlock Motor | RED / orange | | VSM | Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. | Parking Lights+ | brown | | headlight switch | Parking Lights- | | | | Hazards | | | | Turn Signal(L) | | | | Turn Signal(R) | | | | Reverse Light | | | | Door Trigger | BLACK/ lt. blue | + | either kick panel | Dome Supervision | use door trigger | | | Trunk/Hatch Pin | | | | Hood Pin | | | | Trunk/Hatch Release | | | | Power Sliding Door | | | | Factory Alarm Arm | | | | Factory Alarm Disarm | | | | Disarm No Unlock | | | | Tachometer | | | ignition coils | Notes: For tach go to any one of the ignition coils and use the wire that is NOT RED / lt. green. On diesel vehicles the tach wire is green or white, in a 42 pin plug under the clamp on the engine side of the air intake duct. On diesel vehicles the wait to start light is activated by a databus wire from the ECM. To do wait to start use a pulse timer relay and follow directfax document #1091. | Wait to start | see DirectFax document 1091 | | | Brake Wire | lt. green | + | brake pedal switch | Parking Brake | | | | Horn Trigger | blue | - | steering column or VSM | Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening. | Memory Seat 1 | | | | Memory Seat 2 | | | | Memory Seat 3 | | | |
Immobilizer Bypass Module: | Required: No | Type: N/A | Part #: N/A | Notes: N/A |
|
Do it right the first time
draasch
Gold -
Posts: 2,172
Joined: February 07, 2003
Location: Florida, United States
Posted: May 24, 2004 at 8:02 AM / IP Logged
thanks for the info...
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Follow the12volt.com
Tuesday, May 13, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.