2004 acura tl wiring

for this

+12 Volts	White	Ignition Harness	+
Ignition	BLACK / YELLOW	Ignition Harness	+
Accessory	BLACK/ Red	Ignition Harness	+
Starter	BLACK/ white	Ignition Harness	+
Tachometer	Blue	**See Notes	AC
Parking Lights	RED / Black	Driver's kick panel	+
Brakeswitch	WHITE/ Black	At Brake Switch Or Driver's Kick Panel	+
Clutch Bypass	Light Green	At switch	-
Parking Brake	GREEN/ Orange	at fuse box	-
Hoodpin	GREEN/ Black	Hood Latch	-
Lock	Pink/Black	Driver's kick panel	-
Unlock	Pink/Blue	Driver's kick panel	-
Trunk Release	YELLOW /GREEN	Driver's kick panel	Reversal polarity
Arm	WHITE/ Red	Inside Driver's Door	-
Disarm	White	Inside Driver's Door	-
Doorpin	See Notes***	Driver's kick panel	-
Trunk Pin	Blue/Black	Driver's kick panel	-

* Vehicle is equipped with a Transponder anti-theft system and an OEM alarm. ** Tach: Drivers side of engine in harness near firewall. see photo for exact location. *** Driver's Doorpin: Dk.Green (-) Rear Driver's Doorpin: GREEN/ Yellow (-) Passenger Doorpin: Lt.GREEN/ Red (-) Rear Passenger Doorpin: GREEN/ White (-) **** Manual Transmission: Use injector for Tach, if Ready Mode problems occur. ***** A Data Module is available for this vehicle.

ok thanks, now a few ?'s I am hooking up the valet 561r to the stock key pad and will be using the negative off the pink black to activate the remote start.  But my other question is relaying to allow use of the lock twice since the car once started can not use the pad. also what all needs to be hooked up since I am just adding the remote start not using the door locks etc.  also I am running the 556 h I think thats the correct number, it is the one without the key.