neon light connection

Home / the12volt's Install Bay / Lights, Neon, LEDs, HIDs / neon light connection (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

stewiegriffin

Member - Posts: 3

Joined: September 21, 2006

Posted: October 14, 2006 at 6:29 AM / IP Logged

hello.

i want to connect 2 or more neon as dome light ..so when door open neon is on.. how do i do that. ?

thanks

jagcaddy61

Member - Posts: 3

Joined: October 15, 2006

Location: United States

Posted: October 15, 2006 at 2:04 PM / IP Logged

i actually did this a few months ago. if tou have a DVOM, try to trace the circuit back to the fuse panel. open and close the doors to make sure you still have the correct circuit. then wire in the neons from there. you can piggy-back the neon + wires in through the + on the circuit, and i would recommend screwing a sheet metal screw with the neon - wires to the body. make sure you don't blow a fuse. if you do, replace it with an amp rating 5 more than stock. you should be fine though.

Jamie

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

neon light connection

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.