
remote wiring 2006 vw golf
Welcome Guest :)
cyril
Member -
Posts: 24
Joined: January 30, 2008
Location: Alberta, Canada
Posted: June 10, 2008 at 2:20 AM / IP Logged
Can anybody post the wireing for 2006 vw golf, I have not been able to find any info past 2004
Thanks
Cyril
cyri L. Churchill
kola7126
Copper -
Posts: 93
Joined: September 13, 2007
Location: Russian Federation
Posted: June 10, 2008 at 7:13 AM / IP Logged
PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ FUSE BOX, LEFT END of DRIVERS DASH |
STARTER | RED (+) | @ BACK of IGNITION SWITCH |
STARTER 2 | N/A | |
IGNITION 1 | YELLOW (+) | @ BACK of IGNITION SWITCH |
IGNITION 2 | N/A | |
IGNITION 3 | N/A | |
ACCESSORY /HEATER BLOWER 1 | GREEN (+) | @ BACK of IGNITION SWITCH |
ACCESSORY /HEATER BLOWER 2 | GRAY (+) | @ BACK of IGNITION SWITCH |
KEYSENSE | BLUE (+) | @ BACK of IGNITION SWITCH |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | GRAY / YELLOW (+) | @ HEAD LIGHT SWITCH |
POWER LOCK | BROWN / GREEN (1-WIRE Door Lock System) | @ DRIVERS DOOR MODULE in DRIVERS DOOR |
POWER UNLOCK | Same wire, See NOTE *1 | See DIAGRAMS |
DOOR TRIGGER | RED / GRAY (+) or RED / YELLOW (+) | @ UNDER DASH LIGHT |
DOMELIGHT SUPERVISION | RED / PURPLE (-) | @ VESCM, Pin B11, See NOTE *2 |
TRUNK RELEASE | BLUE (-) | @ DRIVERS DOOR MODULE in DRIVERS DOOR or See NOTE *3 |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/ WHITE (+) | @ VESCM Module, See NOTE *2 |
TACH | Any wire NOT RED / BLACK, See NOTE *5 | @ Any FUEL-INJECTOR |
WAIT TO START LIGHT | N/A | |
BRAKE | BLACK/ RED (+) | @ SWITCH above BRAKE PEDAL |
FACTORY ALARM DISARM | DISARMS with FACTORY REMOTE ONLY!!! | |
ANTI-THEFT | VOLKSWAGEN'S TRANSPONDER SYSTEM | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE *1 The LOCK is a Straight (-) NEGATIVE, the UNLOCK is a (-) NEGATIVE thru a RESISTOR, this Resistance value is not known and will need to be measured for each vehicle. To wire the Relays that are required See DIAGRAM. NOTE *2 The VESCM (Vehicle Electrical System Control Module) is part of the RELAY BOX, under the DRIVERS SIDE of the DASH. NOTE *3 The TRUNK/HATCH Release Motor wire is a RED / BLUE (+) at the CSCCM , 18-Pin Plug, Pin 4. NOTE *4 The CSCCM (Comfort System Central Control Module) is located BEHIND the GLOVE BOX. NOTE *5 The TACH Signal can also be found at any IGNITION COIL, use any wire that is NOT RED / GREEN, BROWN / GREEN or BROWN. |
howie ll
Pot Metal -
Posts: 16,466
Joined: January 09, 2007
Location: United Kingdom
Posted: June 10, 2008 at 9:07 AM / IP Logged
Thanks for the info Kola, note that on Polo's and Transporters, that value is 1k.
Follow the12volt.com
Wednesday, May 14, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.