1999 Honda Passport / APS-996

Home / the12volt's Install Bay / Car Security and Convenience / 1999 Honda Passport / APS-996 (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

erijef1

Member - Posts: 2

Joined: March 27, 2003

Location: United States

Posted: March 27, 2003 at 12:16 PM / IP Logged

Does anyone out there have experience with the wiring of the 2 step door locks. I really need some help in that area such as how to do it, where the wires are etc. Also, is it necessary to add a relay for the horn or does it already have one?

Thanks,

Jeff

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: March 27, 2003 at 12:37 PM / IP Logged

Just sent you an email about this, but here it is again if you didn't receive it:

Hey Jeff,

POWER LOCK|lt. GREEN/ red |- |DKP white 22 pin connector

POWER UNLOCK|RED / blue |- |DKP white 22 pin connector

UNLOCK MOTOR|blue/white | |drivers kick panel *1

*1 In a white 10 pin connector

The Red and Green wires will provide either a pulsed ground output to the factory door lock control relay, or

a pulsed + 12 volt output to the factory door lock control relay. In either case, the maximum current draw

through these outputs must not exceed 300 mA. The Red w/Black trace wire will provide a pulsed ground

only, and will only provide an output when the unlock button of the transmitter is pressed a second time

after a first unlock command was issued. This is used for second step unlock or all doors unlock in a two

step circuit. In this arrangement, Red is used to control the drivers door unlock relay, and the RED / Black

will be used to control unlock of all other doors.

RED: LOCK wire on Honda ( LIGHT GREEN/ RED )

RED / BLACK : UNLOCK all doors ( RED / BLUE )

GREEN : Driver's Door Unlock Motor ( BLUE/WHITE )

The horn trigger is a GREEN wire found at the steering column and is a (-) trigger.Use the BLACK/ WHITE wire from the system to operate the horn. If the horn does not respond then you will need a relay to boost the low current signal of the BLACK/ WHITE wire to a solid ground signal. Use this diagram: http://www.velocitymotorsport.com/images/install_notes/N2N. jpg for the relay .

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1999 Honda Passport / APS-996

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.