Install done now CE light

2002 Dodge Ram 1500

554t with remote start

 I just finished a very long install on this vehicle. Everything works fine but I have one problem. The check engine light came on after starting the car with the remote start feature. I figured the cause was the intake plenemum(sp) I removed to gain access to the spark plug harness. I removed the negative battery cable and let the car sit for 10 min. After reconnecting the battery and starting the truck with the key the light was out. I though I had solved the problem. I started the truck again with the remote start and the CE light came on again. The truck runs fine. I picked up the Tach signal at the number 1 cyl plug harness. I did not use the wire that DEI said to stay away from. I checked the AC voltage on the wire before connecting. I doubt this is the problem. When the truck is started with remote start the SRS and Anti Loc lights are on the dash. I think that I need to feed power to another wire in the ign harness. Is it possible to power all other wires that normally have 12 v while running? Has anyone had the same problem? Thanks for the time.

 I used the 16 guage blue wire for ign and the green for the acc.

 I assume that I should splice off the orange wire from the remote start relay bank and use that for the acc 2. I will connect the pink/white to the other ign line. Thanks for the help. It would have been nice to know this before I made everything nice and neat. Thanks again.