2001 Grand am alarm

I hava couple of questions: 1) Does anyone have the factory wireing information for the car?? 2) I have already started to install an alarm on this car, and while inthe process of locating some wires for the dome light, it stopped working. It never comes on at all, not with the manual switch or with the doors. I was not probing the wires with anything when it happend, almost like a fuse went, but I checked all of them. 3) I can't seem to figure out how to hook up the door pin whitch to the car alarm any tips?? Thanks in advance!!

12volts	red	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Starter	yellow	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Starter
Ignition	pink	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Ignition	dk. green	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Third Ignition
Accessory	orange	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Accessory	brown	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Keysense
Power Lock	white	-	black plug in dkp
Notes: Lock requires a negative trigger, and unlock requires a negative trigger through a 1,500 ohm resistor. Must use relays. Must close doors to lock with a single pulse.
Power Unlock	same wire
Lock Motor	gray		drivers kick panel
Unlock Motor	tan		drivers kick panel
Parking Lights+	brown		passenger kick or column
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger		-
Notes: The lt. GREEN/ black is located in the drivers kick and catches only the drivers door. The lt. blue is located in the harness coming from the drivers running board going under the drivers seat and it catches all other doors. Use both door trigger wires and diode isolate each. On the 2 door the lt.blue is in the passenger kick.
Dome Supervision	white	-	dash light or column
Trunk/Hatch Pin	ORANGE / black	-	trunk light
Hood Pin
Trunk/Hatch Release	BLACK/ white	+	drivers kick panel
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	white or PURPLE / wht		ignition coil or ECM
Notes: The ECM is located under the left side of the dash to the left of the column.
Wait to start
Brake Wire	lt. blue	+	at the switch
Parking Brake
Horn Trigger	black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: Yes	Type: Passlock 2	Part #: 555L or 555T
Notes: N/A

Do it right the first time

Thanks for the wiring information it is much better thatn muddling around tring to find the wires...

I have started to install a alarm on a 2001 pontiac Grand Am, and while inthe process of locating some wires for the alarm, the dome light stopped working It never comes on at all, not with the manual switch or with the doors. I was not probing the wires with anything when it happend, almost like a fuse went, but I checked all of them as well as the bulb... all of them are good...any Ideas what happened???? or how to trace for a problem???