790vx shock sensor

hi, I'm trying to install a viper 790vx into my honda civic and was wondering if some one can tell me what the green wire on the shock sensor harness is for since it doesn't connect into the shock sensor? it shows as mutlitiplex input zone 4 in the instal manual. Thanks

i believe it is for pre-warn.....for a dual stage sensor....Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

hi, thanks I got the alarm installed (for the most part any ways) I still have to hook up the remote start and power door locks, but all the doors,trunk and hood sensors all work. (just ran out of daylight) now I just need to figure out how to increase the sensitivity of the shock sensor, I was hoping I would be able to do it through the remote or valet switch, but I didn't notice anything about adjusting the sensors in the manual, does any one know how I would go about doing this? the sensor is mounted directly to the frame using double sided tape. one other thing that I'm not sure about is the led it works fine and flashes normal when armed,but when the system is disarmed it flashes twice about every 2.5 seconds would this be some kind of diognostic? Thanks,