1st time install with valet 562t

Orange(ground when armed output) - where does this go?

• This goes to a starter disable relay: http://www.velocitymotorsport.com/images/install_notes/010.jpg

WHITE/ Blue(- activation input) - where does this go?

• This wire goes to a device that will send a (-) trigger to the unit that your installing and will activate the remote start function.

BLACK/ White(- 200mA domelight output) - do I need a relay to hook this wire up?

• Yes, http://www.velocitymotorsport.com/images/install_notes/105.jpg

Blue(- 2nd unlock output) - where does this go?

• You can have 2nd stage unlock if you wanted to , this allows the first press of the unlock button to just unlock the driver's door and the 2nd unlock press will unlock the other doors. If you want this done you will have to attach the 1st unlock to the driver's door lock motor and the 2nd unlock to the unlock wire of the vehicle.

RED / White(- 200mA channel 2 output) - what is this wire for?

• This is for the control of any function that you want. ie. sunroof close, window close or open, turn on a device, etc. you will need modules or relays for this wire to activate the devices though

Control Module H2:

GREEN/ Black(- factory alarm disarm - do I need a relay for this?

• No relay necessary, just connect to lt. green wire located at either door boot

GREEN / WHITE(- factory alarm rearm) - where does this go?

• can not do this, must use OEM remote to arm system.

Violet/Black(- 200mA channel 4 output) - what is this wire for?

• Same as 2nd channel output.

Control Module H3:

BLACK/ White(neutral safety input) - where does this wire go?

• Not required , this is a automatic vehicle.

Blue/White(- 200mA 2nd status/defogger) - where does this go?

• Used for  rear defrost as description says.

Satellite Relay: Remote Start Auxiary Harness

Blue(- status output) - where does this go?

• THis wire is for any device that needs to be turned on when remote started and this wire looses power to it when remote start function is taken over by driver after brake is depressed. Used for bypass modules mainly or rear defrost as description says.

Orange(- 200mA 2nd accessory output) - where does this go?

• This wire goes to the 2nd function wire as described above. This is a (-) trigger wire that operates a relay to give power to the secondary wire for remote start. This is not applicable to your vehicle.

Purple(- 200mA starter output) - where does this go?

• This wire goes to the 2nd function wire as described above. This is a (-) trigger wire that operates a relay to give power to the secondary wire for remote start. This is not applicable to your vehicle.

Pink(- 200mA 3rd ignition output) - where does this go?

• This wire goes to the 2nd function wire as described above. This is a (-) trigger wire that operates a relay to give power to the secondary wire for remote start. This is not applicable to your vehicle.