Astrostart installation guide 4 02 cavi

does anyone have or can tell me where to get an installation guide 4 installing a astro start #1105 EC with manual interface P/N#310-067-500 and passkey interface? I have already installed this into my cavi but am getting dianostic code #6 (manual interface sequence) Starter will not take over on continious mode and displays  code 6 i am a beginner installer and a "guide for dummies" would be great

 I have officially narrowed it down to 2 problems that I have improper tachometer wire (any help would be great) any improper manual interface wiring if anyone have a guide 4 dummies on these two installs thanx.

i work in an automotive shop and bought it through one of our suppliers. At the end of my valve cover on the drivers side the is a coil pack with two plugs, one has three wires(white,pink and black) second plug has black and pink wires thought that i could do the install myself. have done a few older vechicles but nothing this new or involved. The car will start under automatic transmission mode but the starter does not stop and i have to hold the clutch in to start. Pretty sure that I have the passlockIII interface in properly. Should I b making my starter connection on the engine side of my clutch saftey switch or in the ignition harness by the column? like i said done older vechicles but never a manual and i think that my manual interface is giving me the most problems kinda funny that the interface with only 3 wires is giving me this much problems. Any help would b great!!!!!

i work in an automotive shop and bought it through one of our suppliers. At the end of my valve cover on the drivers side the is a coil pack with two plugs, one has three wires(white,pink and black) second plug has black and pink wires thought that i could do the install myself. have done a few older vechicles but nothing this new or involved. The car will start under automatic transmission mode but the starter does not stop and i have to hold the clutch in to start. Pretty sure that I have the passlockIII interface in properly. Should I b making my starter connection on the engine side of my clutch saftey switch or in the ignition harness by the column? like i said done older vechicles but never a manual and i think that my manual interface is giving me the most problems kinda funny that the interface with only 3 wires is giving me this much problems. Any help would b great!!!!! The starter is running because of no tach signal right or have I done something else wrong.